ZS-5200 スペック調査

アプライアンス機器

目次

概要 †

Zabbix Enterprise Appliance(ZS-5200)のスペック調査手順と結果。

調査 †

CPU †

ARMプロセッサが使用されていることは公開されているが、詳細のスペックは非公開となっている。
Linux上からの調査とチップメーカーの公開情報を元に調査を行う。

以下の情報からスペックを読み取る。

• cpuinfo

  # cat /proc/cpuinfo 
  Processor       : Marvell - PJ4Bv7 Processor rev 2 (v7l)
  processor       : 0
  BogoMIPS        : 1332.01
  
  processor       : 1
  BogoMIPS        : 1332.01
  
  Features        : swp half thumb fastmult vfp edsp vfpv3 
  CPU implementer : 0x56
  CPU architecture: 7
  CPU variant     : 0x2
  CPU part        : 0x584
  CPU revision    : 2
  
  Hardware        : Marvell Armada XP Development Board
  Revision        : 0000
  Serial          : 0000000000000000

• dmesg（抜粋）

  CPU: Marvell - PJ4Bv7 Processor [562f5842] revision 2 (ARMv7), cr=10c53c7f
  CPU: VIPT nonaliasing data cache, VIPT aliasing instruction cache
  Machine: Marvell Armada XP Development Board
  
  〜中略〜
  
  SMP: prepare CPUs (2 cores)
  SMP: CPU 0 Waking up CPU 1
  Armada-XP Performance Monitor Unit detected (Marvell ID)!!!
  hw perfevents: enabled with Armada PJ4 PMU driver, 7 counters available
  CPU1: Booted secondary processor
  Brought up 2 CPUs
  SMP: Total of 2 processors activated (2664.03 BogoMIPS).
  
  〜中略〜
  
   Marvell Armada-XP DB-78460-BP rev 2.0 Board -  Soc: MV78260 A0 LE
   Detected Tclk 250000000, SysClk 667000000, FabricClk 667000000, PClk 1333000000
   LSP version: AXP_2.0.6

メモリ †

以下の情報からスペックを読み取る。

• free

               total       used       free     shared    buffers     cached
  Mem:       3102068    1499776    1602292          0     133708     487856
  -/+ buffers/cache:     878212    2223856
  Swap:      2097148          0    2097148

• dmesg（抜粋）

  Memory: 3071MB = 3071MB total
  Memory: 3071052k/3071052k available, 74672k reserved, 2335740K highmem

HDD †

• dmesg（抜粋）

  sata_mv sata_mv.0: version 1.28
  sata_mv sata_mv.0: cannot get clkdev
  sata_mv sata_mv.0: slots 32 ports 2
  scsi0 : sata_mv
  scsi1 : sata_mv
  ata1: SATA max UDMA/133 irq 55
  ata2: SATA max UDMA/133 irq 55
  
  〜中略〜
  
  ata1: SATA link up 3.0 Gbps (SStatus 123 SControl F300)
  
  〜中略〜
  
  scsi 0:0:0:0: Direct-Access     ATA      ADATA SP900      5.0. PQ: 0 ANSI: 5
  i2c /dev entries driver
  sd 0:0:0:0: [sda] 500118192 512-byte logical blocks: (256 GB/238 GiB)
  sd 0:0:0:0: [sda] Write Protect is off
  sd 0:0:0:0: [sda] Mode Sense: 00 3a 00 00
  sd 0:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
   sda: sda1 sda2 sda3 sda4

NIC †

• dmesg（抜粋）

   o Loading network interface(s)
  
   o Port 0 is connected to Linux netdevice
         giga p=0: mtu=1500, mac=f102fe58
     o eth0, ifindex = 2, GbE port = 0
  
   o Port 1 is connected to Linux netdevice
         giga p=1: mtu=1500, mac=f102fe58
     o eth1, ifindex = 3, GbE port = 1
  
   o Port 2 is connected to Linux netdevice
         giga p=2: mtu=1500, mac=f102fe58
     o eth2, ifindex = 4, GbE port = 2
  
   o Port 3 is connected to Linux netdevice
         giga p=3: mtu=1500, mac=f102fe58
     o eth3, ifindex = 5, GbE port = 3

USB †

• dmesg（抜粋）

  ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
  ehci_marvell ehci_marvell.0: Marvell Orion EHCI
  ehci_marvell ehci_marvell.0: new USB bus registered, assigned bus number 1
  ehci_marvell ehci_marvell.0: irq 45, io base 0xfbb50100
  ehci_marvell ehci_marvell.0: USB 2.0 started, EHCI 1.00
  usb usb1: New USB device found, idVendor=1d6b, idProduct=0002
  usb usb1: New USB device strings: Mfr=3, Product=2, SerialNumber=1
  usb usb1: Product: Marvell Orion EHCI
  usb usb1: Manufacturer: Linux 3.0.6 ehci_hcd
  usb usb1: SerialNumber: ehci_marvell.0
  hub 1-0:1.0: USB hub found
  hub 1-0:1.0: 1 port detected
  ehci_marvell ehci_marvell.1: Marvell Orion EHCI
  ehci_marvell ehci_marvell.1: new USB bus registered, assigned bus number 2
  ehci_marvell ehci_marvell.1: irq 46, io base 0xfbb51100
  ehci_marvell ehci_marvell.1: USB 2.0 started, EHCI 1.00
  usb usb2: New USB device found, idVendor=1d6b, idProduct=0002
  usb usb2: New USB device strings: Mfr=3, Product=2, SerialNumber=1
  usb usb2: Product: Marvell Orion EHCI
  usb usb2: Manufacturer: Linux 3.0.6 ehci_hcd
  usb usb2: SerialNumber: ehci_marvell.1
  hub 2-0:1.0: USB hub found
  hub 2-0:1.0: 1 port detected
  ehci_marvell ehci_marvell.2: Marvell Orion EHCI
  ehci_marvell ehci_marvell.2: new USB bus registered, assigned bus number 3
  ata1: SATA link up 3.0 Gbps (SStatus 123 SControl F300)
  ehci_marvell ehci_marvell.2: irq 47, io base 0xfbb52100
  ehci_marvell ehci_marvell.2: USB 2.0 started, EHCI 1.00
  usb usb3: New USB device found, idVendor=1d6b, idProduct=0002
  ata1.00: ATA-8: ADATA SP900, 5.0.2a, max UDMA/133
  ata1.00: 500118192 sectors, multi 16: LBA48 NCQ (depth 31/32)
  usb usb3: New USB device strings: Mfr=3, Product=2, SerialNumber=1
  usb usb3: Product: Marvell Orion EHCI
  usb usb3: Manufacturer: Linux 3.0.6 ehci_hcd
  usb usb3: SerialNumber: ehci_marvell.2
  hub 3-0:1.0: USB hub found
  hub 3-0:1.0: 1 port detected

OS †

• /etc/debian_version

  6.0.5

• /proc/version

  Linux version 3.0.6 (root@squeeze) (gcc version 4.4.5 (Debian 4.4.5-8) ) #1 SMP Thu Mar 7 19:14:19 JST 2013