- 追加された行はこの色です。
- 削除された行はこの色です。
[[アプライアンス機器]]
目次~
#contents
*概要 [#mad92aed]
Zabbix Enterprise Appliance(ZS-5200)のスペック調査手順と結果。~
*CPU [#hdcc4d05]
**概要 [#l6c5f33e]
*調査 [#hdcc4d05]
**CPU [#l6c5f33e]
ARMプロセッサが使用されていることは公開されているが、詳細のスペックは非公開となっている。~
Linux上からの調査とチップメーカーの公開情報を元に調査を行う。~
**手順 [#jfa73b64]
~
以下の情報からスペックを読み取る。
-cpuinfo
# cat /proc/cpuinfo
Processor : Marvell - PJ4Bv7 Processor rev 2 (v7l)
processor : 0
BogoMIPS : 1332.01
processor : 1
BogoMIPS : 1332.01
Features : swp half thumb fastmult vfp edsp vfpv3
CPU implementer : 0x56
CPU architecture: 7
CPU variant : 0x2
CPU part : 0x584
CPU revision : 2
Hardware : Marvell Armada XP Development Board
Revision : 0000
Serial : 0000000000000000
-dmesg（抜粋）
CPU: Marvell - PJ4Bv7 Processor [562f5842] revision 2 (ARMv7), cr=10c53c7f
CPU: VIPT nonaliasing data cache, VIPT aliasing instruction cache
Machine: Marvell Armada XP Development Board
〜中略〜
SMP: prepare CPUs (2 cores)
SMP: CPU 0 Waking up CPU 1
Armada-XP Performance Monitor Unit detected (Marvell ID)!!!
hw perfevents: enabled with Armada PJ4 PMU driver, 7 counters available
CPU1: Booted secondary processor
Brought up 2 CPUs
SMP: Total of 2 processors activated (2664.03 BogoMIPS).
〜中略〜
Marvell Armada-XP DB-78460-BP rev 2.0 Board - Soc: MV78260 A0 LE
Detected Tclk 250000000, SysClk 667000000, FabricClk 667000000, PClk 1333000000
LSP version: AXP_2.0.6
**メモリ [#n9c51d3b]
以下の情報からスペックを読み取る。~
-free
total used free shared buffers cached
Mem: 3102068 1499776 1602292 0 133708 487856
-/+ buffers/cache: 878212 2223856
Swap: 2097148 0 2097148
-dmesg（抜粋）
Memory: 3071MB = 3071MB total
Memory: 3071052k/3071052k available, 74672k reserved, 2335740K highmem
**HDD [#n1555926]
-dmesg（抜粋）
sata_mv sata_mv.0: version 1.28
sata_mv sata_mv.0: cannot get clkdev
sata_mv sata_mv.0: slots 32 ports 2
scsi0 : sata_mv
scsi1 : sata_mv
ata1: SATA max UDMA/133 irq 55
ata2: SATA max UDMA/133 irq 55
〜中略〜
ata1: SATA link up 3.0 Gbps (SStatus 123 SControl F300)
〜中略〜
scsi 0:0:0:0: Direct-Access ATA ADATA SP900 5.0. PQ: 0 ANSI: 5
i2c /dev entries driver
sd 0:0:0:0: [sda] 500118192 512-byte logical blocks: (256 GB/238 GiB)
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] Mode Sense: 00 3a 00 00
sd 0:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
sda: sda1 sda2 sda3 sda4
**NIC [#rb747023]
-dmesg（抜粋）
o Loading network interface(s)
o Port 0 is connected to Linux netdevice
giga p=0: mtu=1500, mac=f102fe58
o eth0, ifindex = 2, GbE port = 0
o Port 1 is connected to Linux netdevice
giga p=1: mtu=1500, mac=f102fe58
o eth1, ifindex = 3, GbE port = 1
o Port 2 is connected to Linux netdevice
giga p=2: mtu=1500, mac=f102fe58
o eth2, ifindex = 4, GbE port = 2
o Port 3 is connected to Linux netdevice
giga p=3: mtu=1500, mac=f102fe58
o eth3, ifindex = 5, GbE port = 3
**USB [#p79d593b]
-dmesg（抜粋）
ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
ehci_marvell ehci_marvell.0: Marvell Orion EHCI
ehci_marvell ehci_marvell.0: new USB bus registered, assigned bus number 1
ehci_marvell ehci_marvell.0: irq 45, io base 0xfbb50100
ehci_marvell ehci_marvell.0: USB 2.0 started, EHCI 1.00
usb usb1: New USB device found, idVendor=1d6b, idProduct=0002
usb usb1: New USB device strings: Mfr=3, Product=2, SerialNumber=1
usb usb1: Product: Marvell Orion EHCI
usb usb1: Manufacturer: Linux 3.0.6 ehci_hcd
usb usb1: SerialNumber: ehci_marvell.0
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 1 port detected
ehci_marvell ehci_marvell.1: Marvell Orion EHCI
ehci_marvell ehci_marvell.1: new USB bus registered, assigned bus number 2
ehci_marvell ehci_marvell.1: irq 46, io base 0xfbb51100
ehci_marvell ehci_marvell.1: USB 2.0 started, EHCI 1.00
usb usb2: New USB device found, idVendor=1d6b, idProduct=0002
usb usb2: New USB device strings: Mfr=3, Product=2, SerialNumber=1
usb usb2: Product: Marvell Orion EHCI
usb usb2: Manufacturer: Linux 3.0.6 ehci_hcd
usb usb2: SerialNumber: ehci_marvell.1
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 1 port detected
ehci_marvell ehci_marvell.2: Marvell Orion EHCI
ehci_marvell ehci_marvell.2: new USB bus registered, assigned bus number 3
ata1: SATA link up 3.0 Gbps (SStatus 123 SControl F300)
ehci_marvell ehci_marvell.2: irq 47, io base 0xfbb52100
ehci_marvell ehci_marvell.2: USB 2.0 started, EHCI 1.00
usb usb3: New USB device found, idVendor=1d6b, idProduct=0002
ata1.00: ATA-8: ADATA SP900, 5.0.2a, max UDMA/133
ata1.00: 500118192 sectors, multi 16: LBA48 NCQ (depth 31/32)
usb usb3: New USB device strings: Mfr=3, Product=2, SerialNumber=1
usb usb3: Product: Marvell Orion EHCI
usb usb3: Manufacturer: Linux 3.0.6 ehci_hcd
usb usb3: SerialNumber: ehci_marvell.2
hub 3-0:1.0: USB hub found
hub 3-0:1.0: 1 port detected
**OS [#ucaa64b1]
-/etc/debian_version
6.0.5
-/proc/version
Linux version 3.0.6 (root@squeeze) (gcc version 4.4.5 (Debian 4.4.5-8) ) #1 SMP Thu Mar 7 19:14:19 JST 2013
